| Remove the five 5mm Allen head bolts around the
front of the head. Blue arrow depicts longer of 5 bolts. This
bolt must be returned to this position on re-assembly.
|
 |
| Remove the sixteen 6mm Allen bolts (green
arrows), eight 13mm (yellow arrows) and 2 14mm (red arrows) nuts
holding the cam carrier to the head, lift off the carrier.
Carrier is sealed to head with silicone sealer. It will
take some work to break it loose.
|
 |
| Remove the two 10mm bolts securing coolant feed
pipe to cylinder head cooling pipe. Remove hose from water
pump and move pipe aside. |
 |
|
Remove cooling pipe from cylinder head in order to gain
clearance to exhaust manifold nuts.
|
 |
| Remove bolts from exhaust manifold / exhaust pipe
flange. |
 |
| Remove bolt from exhaust bracket at transmission. |
 |
| Remove the two 5mm Allen head bolts from front of
cylinder head. |
 |
| Remove head bolts in order shown. Break the
torque on all bolts, then remove them. |
 |
Remove cylinder head. There is no
need to remove the intake manifold before removing the head.
|
Installation :
|